How to Apply BLADESHARK Hockey Blade Tape

BLADESHARK™ fits both left- and right-handed hockey blades, and is applied to both sides of the blade. Identify which BLADESHARK™ applique goes on which side by matching its shape to the shape of the blade. BLADESHARK™ is tough, waterproof, and durable. It can last for an entire season of play.

Step 1
Remove all tape, wax and dirt from blade. Clean using a mild, non-oily solvent, such as naptha or lacquer thinner.

Step 2
Lightly sand blade until smooth, using sandpaper included. Do not sand through fiberglass or carbon fiber layer.

Step 3
Wipe sanded surface again with a clean solvent-dampened cloth, and allow to dry.

Step 4
Without touching adhesive backing, carefully separate one corner of BLADESHARK™ from backing paper.

Step 5
Position exposed corner of BLADESHARK™ on the blade, and lightly press it down. Pull remaining backing away while adjusting position so that adhesive surface contacts blade evenly. Position so that a uniform margin of the blade is left exposed around top, bottom and wide end of blade.

Step 6
Using firm finger pressure, press BLADESHARK™ evenly onto the blade, working from center toward ends and edges.

Step 7
Lay blade flat on a rolled up towel and apply heavy pressure with heel of hand or pound with fist to bond BLADESHARK™ firmly to blade. Allow to set overnight for best results.

Step 8
Repeat above steps to apply BLADESHARK™ to opposite side of blade.

ORDER NOW and be a Puck Predator with BLADESHARK!

BLADESHARK, Inc.

507 Sheffield Drive
Richardson, TX 75081

email@bladesharkhockey.com
972/800.1544
1-866-99-SHARK (1-866-997-4275)